M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D EVLAN Port Status.Port 14Default ID : 1Filter Status : ENABLED.VLAN Memberships:Vlan: 1 Status: Active UNTAGGEDVlan: 10 Status: Active TAGGEDVlan: 20 Status: Active TAGGEDVlan: 30 Status: Active TAGGEDIn the above example, "show-port" command provides a perspective on which VLANs are associatedwith which ports, whether the VLANs are active, tagged or untagged. While the above instructions areillustrative of how the commands are used, it is recommended to download the tech briefs on how toconfigure VLAN on MNS-6K using Cisco Catalyst® switches or Magnum DX routers. These techbriefs are available on the GarrettCom Inc. web site www.garrettcom.com – under Resources andSupport Æ Software Support. On that page, look for the drop down on “Technical Briefs”List of commands in this chapterSyntax set vlan type= defines the VLAN typeSyntax vlan - allow VLAN commands or configure vlan commandsSyntax vlan – enter the subset of VLAN commandsSyntax add id= [name=] port=[forbid=] [] - adding VLANSyntax start vlan= activate the VLAN configurationSyntax save save the configuration (including the VLAN configuration)Syntax edit id= [name=] port=[] - edit existing VLAN nameSyntax show vlan [] display specific VLAN informationSyntax set-port port= default id= sets the default VLAN id.For Magnum 6K family of switches, the default VLAN id is 1, unless changed using this commandSyntax set-port port= filter status= enables or disablesthe VLAN filtering function.145
