M A G N U M6 KS W I T C H E S ,M N S - 6 KU S E RG U I D E228Magnum6K25(igmp)##mode normalIGMP set to Normal Mode.Magnum6K25(igmp)##exitMagnum6K25#FIGURE126- Setting IGMP-L2List of commands in this chapterSyntaxigmp– IGMP configuration modeSyntaxigmp - enable or disable IGMP on the switchyntaxshow igmp– IGMP operation statusyntaxmcast - enable or disable unknown multicast streams. The default is enabledyntaxset igmp mode=- set the IGMP mode. Normal is when a L3 device is in theyntaxgroup add ip= port= vlan=- add ports to agip>- delete ports from a specific IGMP broadcast groupyntaxshow-group– shows the multicast groupsyntaxset-port port=< port|list|range> mode=- set the portyntaxshow-port– display the port characteristics for IGMPP-enabled router portsables or disables the switch to immediately process a host sending ayntaxset-querier - enables or disables a switch as IGMP querieryntaxset-qi interval=- The IGMP querier router periodically sends general host-query messages.These messages are sent to ask for group membership information. This is sent to the all-system multicastSSSnetwork and is the IGMP root. The IGMP-L2 is used when there is no L3 device in the networkSspecific IGMP broadcastroup del ip=SScharacteristics. Block drops the unregistered multicasts. Forward forwards unregistered multicastsSSyntaxshow-router– displays detected IGMSyntaxset-leave - enleave message rather that wait for the timer to expireSS
