U P D A T I N G S O F T W A R E – S T E P 3Upgrade is Successful. Please reboot Magnum 6Kxx to start the applicationMagnum6K25# rebootProceed on rebooting the switch? [ 'Y' or 'N' ] YDo you wish to save current configuration? [ 'Y' or 'N' ] Y(The switch will now reboot. After the reboot, the Magnum 6K switch may prompt you should theboot code need an update. If prompted, say “Y” to update the boot code. After the reboot andlogin verify the MNS-6K software was upgraded.)Magnum6K25# show versionMNS-6K-Secure Ver: 14.1 Date:Jul 28 2008 Time:07:51:45 Build ID 1217245902FIGURE 169 – upgrading the switch using the serial interfaceNetwork AccessPrerequisites - make sure the directory and the file name of the MNS-6K software imagedownloaded in steps 1 and 2 is known. To upgrade using TFTP or FTP, ensure that theFTP or TFTP server is set up and the switch can ‘ping’ the TFTP or the FTP server andvice-versa. Ensure that the server has access to the MNS-6K software image downloaded instep 2. Make sure the MNS-6K software image file is copied to the default folder specifiedby the FTP or TFTP server. If using FTP services, make sure the FTP access information(login name and password) is also known.In the example below, let us assume that the IP address of the TFTP server is192.168.10.99; that the server can ping the switch and the switch can ping the server.Intentionally left blank for image continuity – image shown on next page350
