U P D A T I N G S O F T W A R E – S T E P 3351Magnum6K25# show versionMNS-6K-Secure Ver: 14.1 Date:Jul 28 2008 Time:07:51:45 Build ID 1217245902Magnum6K25# upgrade mode=tftp 192.168.10.99 file=Rel4.2.binDo you wish to upgrade the image? [ 'Y' or 'N'] YUpgrade is Successful. Please reboot Magnum 6Kxx to start the applicationMagnum6K25# rebootProceed on rebooting the switch? [ 'Y' or 'N' ] YDo you wish to save current configuration? [ 'Y' or 'N' ] Y(The switch will now reboot. Reconnect and login. Verify the MNS-6K software was upgraded.Note – as discussed in step 1, the switch may need a boot code update. After a reboot, the switchawaits a “Y” or “N” on whether the boot code should be updated. If no answer is given, the defaultis not to update the boot code (or a “N”). Since this connection is over the network the question willnot be visible and the boot code will not be automatically updated. See step 4 – updating boot codeover the network on how to update the boot code manually.)Magnum6K25# show versionMNS-6K-Secure Ver: 14.1 Date:Jul 28 2008 Time:07:51:45 Build ID 1217245902FIGURE 170 – Dialog for upgrading the image using tftpThis will load the Rel3.0.bin file from the TFTP server with the IP address (192.168.10.99)on the switch.A similar example using ftp would be similar to what is shown in Figure 16, except thecommand ‘mode=tftp’ will be replaced by ‘mode=ftp’. Make sure the username andpassword for the ftp user is known. If not known, use the user name anonymous with anypassword. Enter the username and password when prompted by the ftp server. Note – ifyou are using MNS-6K version3.0 or lower, it is best to use the FTP server without apassword – i.e. use the anonymous login.Next steps(Optional step) Reload the saved configuration. Update the boot code if needed. This isdescribed in step 4.
