U P D A T I N G S O F T W A R E – S T E P 2343FIGURE 159 - HyperTerminal screen showing the serial settingsNetwork AccessPrerequisites - a PC (or workstation/computer) with telnet software and the IP address ofthe Magnum 6K switch (or DNS name associated with the switch) to be upgraded.Access the Magnum 6K switch by using the telnet command. For example, if the switchhas the IP address 192.168.10.11 the command is as shown in Figure 6 below.C:> telnet 192.168.10.11Trying ….. connected…FIGURE 160 – Using telnet command to connect to a Magnum 6K switch with IP address192.168.10.11If the telnet command does not work – check for network connectivity(using the ‘ping’ command). Please ensure that a personal firewall or otherfirewall settings are not affecting ping or telnet commands. If telnetservices fail10 then the alternative is to locate the Magnum 6K switch andupdate the MNS-6K software through the serial port following the serialupdate process described in this document.Saving the ConfigurationBefore saving the configuration, please ensure that one of the three capabilities listed below areavailable10 telnet services can fail due to a number of reasons. Please check with your system and/or network administrator foradditional help.
