M A G N U M6 KS W I T C H E S ,M N S - 6 KU S E RG U I D ESyntaxgroup add ip= port= vlan=- add ports to aspecific IGMP broadcastgroup del ip=- delete ports from a specific IGMP broadcast groupSyntaxshow-group– shows the multicast groupsSyntaxset-port port=< port|list|range> mode=- set the portcharacteristics. Block drops the unregistered multicasts. Forward forwards unregistered multicastsSyntaxshow-port– display the port characteristics for IGMPSyntaxshow-router– displays detected IGMP-enabled router portsSyntaxset-leave - enables or disables the switch to immediately process a host sending aleave message rather that wait for the timer to expireSyntaxset-querier - enables or disables a switch as IGMP querierSyntaxset-qi interval=- The IGMP querier router periodically sends general host-query messages.These messages are sent to ask for group membership information. This is sent to the all-system multicastgroup address, 224.0.0.1.The default value is 125 seconds. The valid range can be from 60 to 127seconds.Syntaxset-qri interval= -The query response interval is the maximum amount of time that canelapse between when the querier router sends a host-query message and when it receives a response from ahost. The Default value is 10 seconds. The Range can be from 2 to 270 seconds. Restrictions apply to themaximum value because of an internal calculation that is dependent on the value of the Query IntervalSyntaxmode= -Toggle the IGMP mode from L2 to nnormal or IGMP-L2Chapter 19 - GVRPSyntaxshow gvrp- shows whether GVRP is disabled, along with the current settings for the maximumnumber of VLANs and the current Primary VLANSyntaxgvrp >- enable or disable GVRPSyntaxshow-vlan– list all the VLANs (including dynamic VLANs) on the switchSyntaxset-ports port= state=- set the state of the portto learn, block or disable for GVRP. Note the default state is disableSyntaxstatic vlan=- convert a dynamic VLAN to a static VLAN297
