M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D EMagnum6K25# set secrets hideSecrets will be hidden.Magnum6K25# set secrets showSecrets will be visible.Magnum6K25#FIGURE 47 – Hide or display system passwordsErasing configurationTo erase the configuration and reset the configurations to factory default, you can use thecommand ‘kill config’. This command is a “hidden command” i.e. the on-line help and other helpfunctions normally do not display this command. The ‘kill config’ command resets everything tothe factory default. The reset does not take place till the switch reboots.It is recommended to save the configuration (using ‘saveconf’ commanddiscussed above) before using the ‘kill config’ command. The ‘kill config’ willalso reset the IP address and all other parameters as well unless the save optiondescribed below is used.Syntax kill config [save=module-name] – resets the system configuration. The module-nameoption does not reset the specific module parameters. The modules are listed belowThe module-names areName Areas affectedsystem IP Configuration, Boot mode, Users settings (e.g.login names, passwords)event Event Log and Alarm settingsport Port settings, Broadcast Protection and QoSsettingsbridge Age time settingstp STP, RSTP, S- Ring and LLL settingsps Port Security settingsmirror Port Mirror settingssntp SNTP settingsvlan VLAN settingsgvrp GVRP settingssnmp SNMP settingsweb Web and SSL/TLS settingstacacs TACACS+ settingsauth 802.1x Settingsigmp IGMP Settings65
