M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E148Variable or Attribute Default ValueSTP capabilities Disabledreconfiguring general operation priority 32768Bridge maximum age 20 secondsHello time 2 secondsForward delay 15 secondsReconfiguring per-port STP path cost 0Priority 32768Mode NormalMonitoring of STP Not AvailableRoot Port Not setFigure 82 – STP default values – refer to next section “Using STP” for more detailed explanation onthe variables1. By default, STP is disabled. To use STP, it has to be manuallyenabled2. If you are using tagged VLANs, at least one untagged VLAN mustbe available for the BPDU’s to propagate through the network to updateSTP status3. Whenever changes are made to STP, it is recommended to disableand enable STP to ensure the changes are effectiveUsing STPThe commands used for configuring STP are listed below.Syntax show stp - regardless of whether STP is enabled or disabled (default) thiscommand lists the switch’s full STP configuration, including general settings and port settingsMagnum6K25# show stp configSTP CONFIGURATION-----------------Spanning Tree Enabled(Global) : NOSpanning Tree Enabled(Ports) : YES, 9,10,11,12,13,14,15,16Protocol : Normal STP
