M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E158RSTP CONFIGURATION-----------------Rapid STP/STP Enabled(Global) : NOMagnum6K25(stp)##FIGURE 86 – Configuring STP parametersList of commands in this chapter hiscommand lists the switch’s full STP configuration, including gesrt (Enable) or stop (Disable) STP-65535> - specifies the port orswitch level priority. When a port(s) are specified the priority is associated with ports a -Syntax c rt(s)have to be specifiedSyntax p ber|list|range> status= - specific ports may not need toparticipate in STP process. These ports typically would be end-stations. If youSyntax timers forward-delay=<4-30> hello=<1-10> age=<6-160> - change the STP ForwardDelay, Hello timer and Aging timer valuesSyntax show stp - regardless of whether STP is enabled or disabled (default) tneral settings and port settingstp – STP Configuration modeSyntaxSyntax stp - StaSyntax priority [port=] value=<0-255 | 0nd their value is 0255. If no ports are specified, then the switch (bridge) priority is specified and its value is 0-65535ost port= value=<0-65535> - cost is specific to a port and the poort port=are not sure – let MNS-6Ksoftware make the decisions
