M A G N U M6 KS W I T C H E S ,M N S - 6 KU S E RG U I D ELink-Loss-Learn Enabled.Magnum6K25(stp)##lll add port=1,2,3Added Ports: 1,2,3Magnum6K25(stp)##show lllLink-Loss-Learn Status:LLL Status: ENABLEDLLL Enabled on Ports: 1,2,3Magnum6K25(stp)##lll del port=2,3Deleted Ports: 2,3Magnum6K25(stp)##lll disableLink-Loss-Learn Disabled.FIGURE97– Link Loss Learn (LLL) setup. Setup LLL on ports connected to other switchesparticipating in S-RingList of commands in this chapterSyntaxauthorize key=- activate the S-Ring capabilities. Don’t forgetto use the “save” command to save the keySyntaxstp– STP Configuration modeSyntaxstp - Start (Enable) or stop (Disable) STPSyntaxset stp type=- set the spanning tree protocol to be IEEE 802.1d or 802.1w(Spanning Tree Protocol or Rapid Spanning Tree Protocol)Syntaxshow active-stp– Display which version of STP is currently activeSyntaxshow s-ring– show the status of S-Ring status and configurationSyntaxs-ring -enable or disable S-Ring capabilitiesSyntaxs-ring learn–start the learning process to discover the ring and the ports which make up the S-RingSyntaxs-ring add port=-define ports which make up the S-ring ports. Note asdiscussed earlier, you can create multiple S-Rings on a switchSyntaxs-ring del port=- remove the switch from S-Ring topology by eliminating theend ports on the switchSyntaxlll - enable or disable LLL on the switch185
