18 DTMFFUNC (K)/Ver. 1.01 Confidential Contents Index 6518.1.3 Keypad Auto PTTKeypad Auto PTT can be used to send the correspondingDTMF codes automatically when one of the [0] to [9], [*]and [#] keys on the keypad is pressed.Keypad Auto PTT can be configured to be enabled ordisabled by using KPG-101D.Table 18-2 DTMF Tone Key Operation Transceiver Operation1. Press a key corresponding to the DTMF code tosend.The transceiver sends the DTMF codecorresponding to the selected key.2. Repeat step 1 if necessary. Configuration using KPG-101D• Assigning functions to the Keypad Operation(Refer to FPRG 6.8.2 General Tab - KeypadOperation.)18.1.4 Autodial List SelectionAutodial List Selection can be used to select a DTMFcode stored in the Auto Dial Memory List and send thecode.Autodial List Selection is available when Store & Send isdisabled. Transceiver Operation1. Press the Autodial key.2. Press the [0] to [9] keys.The transceiver enters the Shortcut Entry Mode ofList Selection.The smallest Autodial list number appears on thedisplay immediately after the transceiver is turnedON. Otherwise, the previous list number appears.Select “DTMF (Autodial)” from the KeyAssignment window > General tab > KeypadOperation dropdown list unless the Autodial keyis used.3. Select the Autodial List.• Using the PF KeysPress the [ or [C>] key.• Using the Selector *1Turn the Selector.*1 If the List Selection Key (Selector) is enabled.4. Press the PTT switch to send the DTMF code andvoice.Press the Side 2 key to send the DTMF code only.The transceiver sends the DTMF code.Frequency DTMF Digit941.000 + 1336.000 Hz DTMF Code “0”697.000 + 1209.000 Hz DTMF Code “1”697.000 + 1336.000 Hz DTMF Code “2”697.000 + 1447.000 Hz DTMF Code “3”770.000 + 1209.000 Hz DTMF Code “4”770.000 + 1336.000 Hz DTMF Code “5”770.000 + 1447.000 Hz DTMF Code “6”852.000 + 1209.000 Hz DTMF Code “7”852.000 + 1336.000 Hz DTMF Code “8”852.000 + 1447.000 Hz DTMF Code “9”941.000 + 1209.000 Hz DTMF Code “*”941.000 + 1447.000 Hz DTMF Code “#”