Kenwood TK-2170 Series Function Reference

Also see for TK-2170 SERIES: Service manual Instruction manual Instruction manual Specifications Service manual

18 DTMFFUNC (K)/Ver. 1.01 Confidential Contents Index 7318.3.12 Selective Call Alert LEDSelective Call Alert LED can be used to make theSelective Call Alert LED blink when the transceiverreceives a code.This function allows a user to monitor a call when awayfrom the transceiver.Selective Call Alert LED can be configured to be enabledor disabled by using KPG-101D. (Refer to 20.2 SelcallFunction on page 82.) Configuration using KPG-101D• Configuring the Selective Call Alert LED (Refer toFPRG 6.10.2 Decode Tab - Selective Call AlertLED.)18.3.13 DTMF Number DisplayDTMF Number Display allows a user to view a receivedDTMF code if the transceiver receives a DTMF code withat least 3 numeric digits. The received code appears onthe display while the Channel Name or DTMF codeappears on the display.The display is updated when the transceiver does notreceive another code for more than 1 second after thetransceiver received the DTMF code. Only the first 8numeric digits can be displayed if the transceiver receivesa code with more than 8 numeric digits.DTMF Number Display functions only for a channel onwhich Off is configured for DTMF signaling and DTMF isconfigured for Optional Signaling. The display is notupdated in the following conditions:• When the transceiver receives the Stun Code or StunDeactivation Code.• When the transceiver is in Emergency Mode.The previous channel appears on the display if any key ispressed while the DTMF code appears on the display.The previous CH/GID appears on the display when theAuto Reset Timer expires if the display for the Auto ResetTimer is configured.DTMF Number Display can be configured to be enabledor disabled by using KPG-101D.Note: DTMF Number Display is only used for viewing the caller’s ID.A user cannot reply to the ID displayed on the display. Optional Signaling cannot be decoded if DTMF Number Displayis enabled. Configuration using KPG-101D• Configuring the DTMF Number Display (Refer to6.12.2. Decode Tab - DTMF Number Display(Conventional).)18.4 AutodialThe following functions relevant to Autodial can beconfigured by using KPG-101D:• Autodial List• Autodial Programming18.4.1 Autodial ListAutodial List can be used to configure the DTMF codeused in Autodial.Autodial List can be configured by using KPG-101D.Below is a list of configuration items for Autodial List.Table 18-10 Autodial List Configuration Configuration using KPG-101D• Configuring the Name (Refer to FPRG 6.10.3Autodial List Tab - DTMF Name.)• Configuring the Code (Refer to FPRG 6.10.3Autodial List Tab - Code.)18.4.2 Autodial ProgrammingAutodial Programming can be used to configure, changeor delete the Autodial List using the PF key.Name and DTMF code can be changed by pressing theAutodial Programming key while Autodial Programmingis enabled.Autodial Programming can be configured to be enabledor disabled by using KPG-101D.Note: Keys operate as below if the List name or the DTMF code isentered.Autodial List OperationNameA name can be assigned to the DTMFcode. A maximum of 8 characters canbe configured for each DTMF code.CodeThe DTMF code to send can beconfigured. A maximum of 16characters can be configured for eachDTMF code.