Kenwood TK-2170 Series Function Reference

Also see for TK-2170 SERIES: Service manual Instruction manual Instruction manual Specifications Service manual

20 FLEETSYNCFUNC (K)/Ver. 1.01 Confidential Contents Index 85z Display when an ID is registered in the ID List(Supervisor Call)z Display when no ID is registered in the ID List(Supervisor Call)z Display when an ID is registered in the ID List(Broadcast Call)z Display when no ID is registered in the ID List(Broadcast Call)Note: When the transceiver receives a Group Call, Fleet Call, orBroadcast Call, the Fleet and ID of the received Selcallappear on the display instead of the Fleet and ID of thecaller. Since the call information is more important than thecaller’s information.20.2.3 ID ListThe transceiver uses an individual FleetSync ID forcommunications if FleetSync is enabled. The receivingparty’s FleetSync IDs must be pre-programmed in thetransceiver by using KPG-101D. The transceiver canstore a maximum of 100 FleetSync IDs.The following functions can be configured in the ID List byusing KPG-101D.Table 20-5 ID List Configuration Configuration using KPG-101D• Configuring the ID List (Refer to FPRG 6.12.4 IDList Tab.)ID List OperationFleetConfigures the Fleet of the FleetSync ID. Select ALLor a value between 100 and 349.A user can call all transceivers in the same Fleet.IDConfigures the ID of the FleetSync ID. Select ALLor a value between 1000 and 4999.A user can call all transceivers having the sameID.ID NameConfigures the caller’s ID name. A maximum of 8characters can be configured for the ID Name.If the transceiver receives an Individual Call andthe received Fleet and ID are configured in the IDList, the ID Name of the caller appears.The Call ID Name appears on the display whenthe transceiver receives a Selcall other thanIndividual Call and the received ID is configured inthe ID List.TransmitInhibitEnables or disables the transmit capability.When the transceiver receives a call from the IDconfigured for Transmit Inhibit, the ID does notappear on the ID Selection window and a usercannot select the ID.The caller’s ID Name appears if the transceiverreceives a call from the ID configured for TransmitInhibit. In this case, a user cannot respond even ifthe PTT switch is pressed.