Installing the Operating System with Express Setup 5-9Installing the Windows Server 2003Express Setup proceeds the setup by specifying the necessary information on the wizard. You canalso save the setup information created on the wizard in a floppy disk as a setup file.NOTE: One floppy disk formatted by MS-DOS 1.44MB is necessaryto save the setup information. Please prepare a floppy disk by yourselfbefore the installation.Using the same setup file you saved and used before allows you toomit specifying the setup information on the wizard.And if you use a floppy disk which is attached to the optional devicesuch as disk array controller and contains device driver to installoptional mass storage driver while processing the Express Setup, youhave to save the setup information in the setup file. Please prepare oneempty floppy disk for setup file in this case, too.1. Turn the power of peripheral device on, and then turn on the server.NOTES: If you operate installing Windows Server 2003 with MO deviceconnected, the installation may not be completed normally. In suchcase, detach MO device and then re-install the system from thebeginning. Connect the hard disk drive that OS is not going to be installedafter installing OS. If you create multiple logical drives in your system, refer to"Reinstalling the operation system when multiple logical drivesexist" (Appendix D).2. Insert the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.3. Press the RESET switch or press Ctrl, Alt, and Delete to reboot from the NECEXPRESSBUILDER. (You may also turn off and then on again to reboot the server.)The system will boot from the CD-ROM and NEC EXPRESSBUILDER starts.4. Click [Express Setup].5. The message, "Do you want to use the parameter file in order to set up the Express Serveror Workstation?", will be displayed.If you use the setup parameter file, click [Yes] and if you do not use the setup parameterfile, click [No].6. "Note" will be displayed. Read the instruction carefully and click [Confirm].