General Description 2-27IMPORTANT: If the CD-ROM drive produces large noise after thesetting of a CD-ROM, reload the CD-ROM.To remove a CD-ROM, press the Open/Close button to eject the tray, as described for inserting it,and then take the CD-ROM out of the tray. (The orange-lit access lamp indicates ongoing diskaccess. The Open/Close button does not work while the lamp is lit.)Your OS may have a command to eject the tray.When you have taken out the CD-ROM, retract the tray back in place.When you fail to eject:When you fail to eject the CD-ROM tray with the Open/Close button and take out the CD-ROMfrom the server, follow the procedure below.1. Press the POWER switch to power off the server. (The POWER/SLEEP lamp goes off.)2. Insert a metal pin of approximately 1.2 mm in diameter and 100 mm in length (astraightened large paper clip will make a substitute) into the emergency hole on the rightfront of the CD-ROM drive and gently push it in until the tray is ejected.IMPORTANT: Do not use a toothpick or plastic stick that is easy to break. If the above procedure does not let you take out the CD-ROM,contact your sales agent.3. Hold the tray and pull it out.4. Take out the CD-ROM.5. Push the tray back into position.
