4-12 Configuring Your ServerSecurityIMPORTANT: Set the passwords only after OS is installed.Option Parameter Description Your SettingAdministratorPassword IsInstalledNot InstalledStatus only, user cannot modify.Once set, this can be disabled bysetting it to a null string, or by clearingpassword jumper on system board(see Configuring Mother BoardJumpers in this Chapter).User Password Is InstalledNot InstalledStatus only, user cannot modify.Once set, this can be disabled bysetting it to a null string, or by clearingpassword jumper on system board(see Configuring Mother BoardJumpers in this Chapter).Set AdministratorPasswordUp to sevenalphanumericsWhen the Enter key is pressed, theuser is prompted for a password;press Esc key to abort. Once set, thiscan be disabled by setting it to a nullstring, or by clearing password jumperon system board (refer to ConfiguringMother Board Jumpers in thischapter). Set password to null to clear.Set UserPasswordUp to sevenalphanumericsAdministrator password controlsaccess to the setup utility.When Enter is pressed, the user isprompted for a password; press Escto abort. Once set, this can bedisabled by setting it to a null string, orby clearing password jumper onsystem board (refer to ConfiguringMother Board Jumpers in thischapter). Set password to null to clear.User Access Level No AccessView OnlyLimited[Full Access]"No Access" prevents user access tothe SETUP utility."View Only" allows access to theSETUP utility but no parameters arechangeable."Limited" allows only limited fields tobe changed.Clear UserPasswordPress Enter Running this menu immediately clearsthe user password.Fixed disk bootsector protect[Disabled]EnabledWill write protect the boot sector of thehard drive to prevent viruses fromcorrupting the drive under DOS if setto write protect.Password on boot [Disabled]EnabledDisables or enables password entryon boot.
