Configuring Your Server 4-19CONFIGURING MOTHER BOARD JUMPERSWith the pre-installed SETUP utility, you can set desired passwords to protect the data stored in theserver against access from unauthorized users. When you forget the passwords, however, you maywant clear them. The following describes how to clear these passwords. You can also use thefollowing procedure to clear the CMOS data in the server.IMPORTANT: Clearing the CMOS data resumes the factory-setconfiguration data.To clear passwords or the CMOS data, use the jumper switch on the mother board of the server.The following figure illustrates the jumper switch location.IMPORTANT: Do not change any other switch settings. Anychange may cause the server to fail or malfunction.: Strap N.A. N.A.Preservesthe contentsof CMOS*Enablespasswordprotection*N.A. ClearsCMOSDisables thepasswordN.A.* Factory-set