Troubleshooting 8-31RECOVERY FOR Windows 2000 SYSTEMIf any file necessary for running the OS is damaged, use the following procedures to recover thesystem.IMPORTANT: After recovering the system, see "Updating the System" in Chapter5 and be sure to update the system.Also on Windows 2000, you need to update all the drivers after thesystem update. For more information, see "Installing and SettingDevice Drivers" in Chapter 5. If the hard disk can not be recognized, you can not recover thesystem.Follow the procedure below and use the information in the disk, not system recovery disk, torecover the system.1. Turn on the power of the system.2. Insert Windows 2000 CD- ROM into the CD-ROM drive of your server.3. Press the RESET switch or press Ctrl, Alt, and Delete to reboot the server. (You mayalso turn off and then on again to reboot the server.)4. Press F6 while the message "Setup is inspecting your computer's hardwareconfiguration..." is displayed at the upper part of the screen.NOTE: Nothing is changed on the screen through F6 is pressed.5. Press S when the following message appears:Setup could not determine the type of one or more mass storage devicesinstalled in your system, or you have chosen to manually specify an adapter.Currently, Setup will load support for the following mass storage devices.Select [Other] and press Enter.6. Insert Windows 2000 OEM-DISK for NEC EXPRESSBUILDER into the floppy diskdrive and press Enter.Please insert the disk labeledmanufacturer-supplied hardware support diskinto Drive A:* Press ENTER when ready.