3-10 Setting Up Your ServerTURNING ON THE SERVERTurn on the server and follow the on-screen instructions for setup.IMPORTANT: Before turning on the server: Some optional boards require setups with the SETUP utility beforeinstallation. If the server has a PCI board with the PCI-to-PCIbridge installed, the SETUP utility is enabled to launch. Check onthe board specifications to find out whether it requires pre-installation setups before actually installing the board. Some installed optional devices or connected peripheral devicesrequire setups before proceeding to the next step.1. Make sure that the floppy disk drive contains no floppy disk and the CD-ROM drivecontains no bootable CD-ROM.2. Press the POWER switch.NOTES: If the power cord is connected to the power control unit such as theUPS, turn on the power control unit. Connect the power cord and wait a few seconds before pressing thePOWER switch. The POWER switch does not work in a fewseconds after connecting the power cord due to firmware start-up.POWER/SLEEP lamp
