5-48 Installing the Operating System with Express SetupNotesThe following explains general notes on HostRAID:For notes on the BIOS setup utility, refer to Chapter 4 of this manual. For notes on ASMBE, refer toAdaptec Storage Manager™ - Browser Edition User's Guide.NOTE: You may view or print the Adaptec Storage Manager™ -Browser Edition User's Guide from the NEC EXPRESSBUILDERCD-ROM. Only use the HostRAID drive as a system drive. Only a hard disk drive can be connected to a channel with which HostRAID is enabledthrough the BIOS setup utility. To connect a device other than a hard disk drive, disable HostRAID and use it as thestandard SATA. In addition to driver installation, ASMBE installation is mandatory for using HostRAIDfunctions. For the installation of ASMBE, refer to the "Adaptec Storage Manager™ -Browser Edition User's Guide." If you replace a hard disk drive being used with HostRAID, please replace the hard diskdrive after power-off of the system. Be sure to check the PORT number of the hard diskdrive to be replaced in ASMBE in advance. HostRAID does not permit the use of the standby/hibernation mode of ACPI functions. Use ASMBE to maintain HostRAID, but do not use any other utilities. If the following messages are included in the application log or log generated by theASMBE, your RAID system operates normally.– Spare test failed for pool spare (bus=%2, ch=%3, id=%4)– Test of all spares completed with %1 failures