Configuring Your Server 4-11Boot Settings Configuration submenuOption Parameter Description Your SettingQuick Boot Disabled[Enabled]This option allows BIOS to skipseveral tests during the POSTsequence. This will decrease thetime required for booting thesystem.Quiet Boot Disabled[Enabled]If enabled, the BIOS will displaythe NEC logo during POST.Press Esc to switch to the POSTexecution screen.Bootup Num-Lock [Off]OnSets power on Numlock state.PS/2 Mouse Support DisabledEnabled[Auto]Specify whether BIOS supportsfor PS/2 mouse.Post Error Pause Disabled[Enabled]Indicates whether POST isaborted once at the end of POSTif an error occurs during theexecution of POST.Hit 'F2' Message Display Disabled[Enabled]Displays "Press F2 to run Setup"message in POST.Scan User Flash Area [Disabled]EnabledThis option allows BIOS to scanthe flash ROM for user area.[ ]: Factory-setBoot Device Priority submenuThe Boot Device Priority submenu specifies the boot sequence from the available drives specifiedin the Hard Disk Drives, Removable Drives, and CD/DVD Drives submenus, the onboard networkinterface controller (for PXE boot), and the EFI boot function.The factory-default boot order is listed below.1. CD-ROM drive2. Floppy disk drive3. Hard disk drive4. Network interface controller5. EFIThe server searches for devices in the order set in this menu on booting. Finding the boot software,the server starts the software.The priority of the boot devices can be changed by using the ↑, ↓, +, and - keys. Move the cursorto the desired device with the ↑ or ↓ key and change the priority with the + or - key.IMPORTANT: To boot NEC EXPRESSBUILDER, set the priority ofthe devices listed above.