Section 700 - Operation Chapter 6. DSLT Features576-36-700 DBS 576 (USA) issued October 2000 6-37To transfer a call using OHVA:Hardware Requirements• N/ARelated Programming• FF1 0 03 (System): Extension COS OHVA Originate• FF1 0 03 (System): Extension COS OHVA Receive• FF3 (Extension): Extension COS Assignments• FF4: FF Key AssignmentsConsiderations• If Onhook Transfer is enabled, the held call is transferred as soon as the extension sending theOHVA hangs up.• If the transferred call is not answered immediately, it will queue for a set time limit, then returnto the extension sending the OHVA by Transfer Recall Timer.• You cannot receive a Call Waiting message during an OHVA.• If you make an OHVA to an SLT, the SLT user and the other party will hear the announcement.Onhook DialingDescriptionOnhook Dialing allows users to dial without lifting the handset. However, the Digital Single LineTelephone (DSLT) does not have a microphone so you must lift the handset to talk.OperationTo use onhook dialing:Action Result1. While on a call, press the HOLD key. Current call on hold2. Dial the extension number to which the call is being trans-ferred.Busy signal3. Enter OHVA feature access code (default = 8) and announcethe call to be transferred.4. If transfer is: not accepted, press the FLASH key. Transfer canceled5. Replace the handset.Action Result1. Press the ON/OFF key. Intercom dial tone2. Enter a trunk access code, or dial an extension number.
