6-44 DBS 576 (USA) issued October 2000 576-36-700Chapter 6. DSLT Features Section 700 - Operation* Indicates that the digits that follow are either a feature access code or an extensionnumber. (Not needed if your System is set for Intercom Level.) See Note below.** Indicates that the digits that follow are for an outside number and the System shouldseize the next available trunk when dialing. (Not needed if your System is set for COLevel.) See Note below.Note: The System has two levels - CO Level and Intercom Level. If set at CO Level(default), you must enter the code for Intercom Level when programming a feature accesscode or extension number for speed dialing. If the System is set at Intercom Level, you mustenter the MCO Code when programming an outside number for speed dialing.System Speed DialYou can store frequently called numbers using the SSD feature. Either 80 or 800 SSD numbers can beprogrammed, depending on how the System is configured. In an 80 SSD-number system, the SSDnumbers are stored in bins 00-79. In 800 SSD-number systems, the SSD numbers are stored in bins000-799.OperationTo assign SSD numbers:To dial an SSD number by entering the speed dial bin number:Hyphen (-) PROGDTMF Conversion After theOther Party AnswersAUTO * 3(Version 2.1 orhigher)Action Result1. Lift the handset or press the ON/OFF key. Intercom dial tone2. Enter the Speed Dial Set/Clear code (default = 710).3. Enter the SSD bin number (00-79 or 000-799).4. Dial the phone number.5. Press the HOLD key.6. Replace the handset or press the ON/OFF key.Action Result1. Lift the handset or press the ON/OFF key. Intercom dial tone2. If necessary, access an outside line. Outside dial tone3. Press the AUTO key.OR...Enter the Speed Dial Originate code (default = 80).To indicate . . . Enter/Press
