7-16 DBS 576 (USA) issued October 2000 576-36-700Chapter 7. SLT Features Section 700 - OperationOperationTo place a call on Broker’s Hold:Hardware Requirements• N/ARelated Programming• F1-0-03: Extension COS (Hookflash Control on SLTs - Broker’s Hold or Conference)• FF3: Extension COSConsiderations• If Broker’s Hold is enabled, it is not possible to establish a conference call from an SLT position.Call ParkYou can use the Call Park function to transfer a call, even if you cannot locate the intended recipientof the call.CO, Extension, and Network calls may be parked.There are two ways for an extension to park a call. One way is to park the call at the receivingextension and to retrieve the parked call at another extension by dialing the park answer code plus theparking extension number. The other way is to park the call at another extension and dial the parktransfer answer code at the other extension to retrieve the call. Beginning with Version 3.6, anExtension Group Pickup code allows the user to pick up a Transfer Recall (only on non-appearingcalls), a Hold Recall, and a Station Park Recall.To park a call on this extension:Action Result1. Pick up the first call.2. Hookflash. First call on hold3. Pick up the second call.4. Hookflash. Second call on hold, first call retrievedAction Result1. While on a call, press the hookswitch.. • Intercom dial tone2. Enter the Station Call Park code (default = 771).3. If necessary, page the party that needs to retrieve the call.
