Section 700 - Operation Chapter 3. System Features576-36-700 DBS 576 (USA) issued October 2000 3-61Call Forward ID Code for Voice MailCall Forward ID Code for Voice Mail allows you to call forward to a third-party Voice Mail system.The ID Code sends the digits that are required by the Voice Mail to identify the System extension.OperationTo set a Call Forward ID Code for Voice Mail:To clear the ID Code:Hardware Requirements• N/ARelated Programming• N/AConsiderations• N/ADID/DNIS/DDI Voice Mail ID CodeDID/DNIS/DDI calls may be sent directly to voice mail through the used of the DID Voice Mail IDCode. A prefix and suffix may be specified to be sent to the voice mail as well as a chosen number ofDID digits.Either no digits (default), the last two digits of the DID, the last three digits of the DID or the entireDID number may be sent.The prefix may be up to eight digits including 0-9, *, # and pause (REDIAL).The suffix may be up to eight digits including 0-9, *, # and pause (REDIAL).Action Result1. Go offhook or press ON/OFF key.2. Dial the Call Forward ID Code (default = 715). Enter V.M. ID displays3. Enter the ID code required by voice mail (see your voicemail manual). Usually this is the extension number.4. Press the HOLD key. Stored V.M. ID displays5. Go onhook or press ON/OFF key.Action Result1. Go offhook or press ON/OFF key.2. Dial the Call Forward ID Code (default = 715) Enter V.M. ID displays3. Press the HOLD key. Cleared V.M. ID displays4. Go onhook or press ON/OFF key.
