5.5 SETTING MAILBOXESInstallation Manual 169From Mailbox Setting Menu:Enter the data using the following table as a guide.Table 5-8Parameter Value Range(Default)Description/FunctionDial Number Up to 32 digitsconsisting of 1-9,0, , #P, T, M, X(None)Assigns a telephone or beeper number to Device 1, 2,or 3. The subscriber can also specify the dial numberfrom his telephone.P: PauseT: Dial Tone DetectionM: Dial Mode Switching Code (Touchtone to Pulse, orPulse to Touchtone)X: Callback Number Entry Code1-9, 0, , #: Dial CodesNoteThe callback number entry code "X" must beincluded in the number to be called if the BeeperCallback No. Entry Mode is enabled through COSand "Type of Device" is set to "Beeper". The propernumber of "Pauses" must be inserted before thecallback entry code.NoticeWhen the VPS calls to a CO line via a PRI (ISDNPrimary Rate Access Interface) card of aPanasonic PBX, please be sure to add "#" after thetelephone number (1112223333 in the examplehere):Example: 9P1112223333#PP123PP456PPX#Please contact your System Administrator for moreexplanation.Type ofDevice1. Telephone2. Beeper(Telephone)Specifies the device to receive notification. This isautomatically set to "Beeper" when "X" is used in theDial Number (above). The subscriber can also specifythe type of device from his telephone.Enter The Number : = 1Enter the Mailbox number: =Program - Mailbox Setting - Enter/Edit Menu1. Mailbox Setting2. Notification Setting3. Remote Call FWD to COEnter The Number : = 2Program - Mailbox Setting - Enter/Edit - Notification Setting1. 1st Device2. 2nd Device3. 3rd DeviceEnter The Number : =
