B7 SYSTEM ADMINISTRATION—HARDWARE SETTINGSInstallation Manual 329To program the following 10 Parameters in the next table, use the Special Commands and DialCodes listed below. You can set up to 12 digits for each parameter.D: DisconnectingF: Hook FlashR: Ringback Tone DetectionS: Silence DetectionT: Dial Tone DetectionW: Wait for 1 sX: Extension dialingA: Answer1-9, 0, , #: Dial CodesTable B-44Parameter Value Range(Default)Description/FunctionOperatorTransferSequence(FXA)The VPS performs this sequence when transferring callsto the operator’s extension.ExtensionTransferSequence(FXA)The VPS performs this sequence when transferring callsto any extension except the operator’s.AlternateExtensionTransferSequence(FXA)The VPS performs this sequence when transferring callsto extensions in the Alternate Extension Group.ReconnectSequence onBusy(F)If an extension is busy, this sequence allows the VPS toreconnect to the caller.ReconnectSequence onNo Answer(F)If the extension does not answer, this sequence allows theVPS to reconnect with the caller.ReconnectSequence onRefuse Call(F)The VPS performs this sequence to retrieve a call placedon hold after the extension (in the Call Screening mode)has refused to accept it.Light-OnSequencefor MessageWaitingLamp(None)This is the dialing sequence that the VPS must perform toenable the Message Waiting Lamp at an extension.Light-OffSequencefor MessageWaitingLamp(None)This is the dialing sequence that the VPS must perform todisable the Message Waiting Lamp at an extension.
