D7 REMOTE CALL FORWARDING SET382 Installation Manual• [6] FWD Cancel4. For the items selected in Step 3, follow these steps:• For FWD All—Go to Step 5.• For FWD Busy—Go to Step 5.• For FWD No Answer—Go to Step 5.• For FWD Busy or No Answer—Go to Step 5.• For FWD to CO—Go to Step 7.• For FWD Cancel—Go to Step 10.5. Type the extension number.6. Confirm the entry is correct and Press [2] to accept it. Go to Step 11.NotePress [1] to change the extension number—Return to Step 5.7. Press [1] or [2] to select Telephone number 1 or Telephone number 2 (Go to Step 9), orPress [3] to select another telephone number.8. Type the telephone number using "0-9" and " ".Notes• Please make sure you begin the telephone number with a Line Access Code (to seizea CO line).• When connected to the KX-TD500, the maximum number of characters allowed tobe entered is 24; when connected to other KX-T series PBX, 16.9. Confirm the entry is correct and Press [2] to accept it. Go to Step 11.NotePress [1] to change the telephone number. Return to Step 7.10. Call Forwarding is canceled. Press [2] to accept it.11. Call Forwarding setting data is transmitted to the PBX. If the forwarding setting orcanceling has been completed properly, you will hear: "Call forwarding accepted" or "Callforwarding is canceled".NoteIf you hear "Call Forwarding not accepted. Please check the destination number", theforwarding setting has not been completed properly at the PBX, possibly because anonexistent extension number has been entered as the destination. It is also possible thatthe model of the connected PBX does not support the Remote Call Forwarding Setfeature, or its software version is lower than required; for more information, call NationalParts Center at 1-800-833-9626.
