Tascam SS-CDR1 Owner's Manual

Also see for SS-CDR1: Technical documentation

Contents

1 − Introduction10 TASCAM SS-CDR1The pinouts of the CONTROL I/O (PARALLEL) terminalon the rear panel (see “Rear panel” on page 13) are:Pin Function IN/OUT1 GND —2 Play/Flash 1 In3 Stop/Flash 2 In4 Record/Flash 3 In5 ≤ (Next)/Flash 4 In6 μ (Previous)/Flash 5 In7 Flash Load In8 Fader Start In9 Flash Tally Out10 Ready Tally Out11 Record Tally Out12 Stop Tally Out13 Play Tally Out14 Remote Select*2 In15 Ready/Flash 6 In16 Call/Flash 7 In17 Auto Cue/Flash 8 In18 Auto Ready/Flash 9 In19 Pitch/Flash 10 In20 Flash Page*3 In21 EOM Tally Out22 CF Tally Out23 — —24 CD Tally Out25 +5V*1 —In: External command reception active flow(operates at 30 ms or longer of ground)Out: transport status by open drainIndication signal (maximum voltage 50 V, maximum current50 mA)*1 Maximum supplied current is 50 mA.*2 Pin 14 (Remote Select)When this pin is high, the input pins for which the abovetable lists two commands separated by a “/” (pins 2–6and 15–19) will perform the first-listed function, and canbe used as conventional parallel controllers.When this pin is low, the above-listed input pins will func-tion as flash start keys.*3 Pin 20 (Flash Page)When pin 14 (Remote Select) is low, the assigned trackswill be as follows according to the high/low state of pin20.#14 #20 Flash-start statusLow High 1–10Low Low 11–20Tall signals are open collector, with a maximum currentof 50 mA. Input signals are active when low (ground)for ≥ 30 ms.A fader start/stop control should be wired according to thefollowing schematic:STARTSTOPPin 1FADER STARTPin 8GNDPARALLELControl connectionsThe following should be noted when you connect the unitto other equipment.It is possible to connect the unit’s DIGITAL COAXIAL IN,and balanced or unbalanced ANALOG INs (L, R) to otherequipment at the same time. However, the unit can receivesignals from only one input at a time. Currently selectedinput jack is shown on the display.Audio signals output from the unit are output from thebalanced or unbalanced ANALOG OUT jacks, as well asfrom the DIGITAL COAXIAL OUT connector simultane-ously (but not from the digital output in stop mode).Connections