IMPORTANT SAFETY PRECAUTIONS4 TASCAM SS-CDR1Rack-mounting the UnitUse the supplied rack-mounting kit to mount the unit in astandard 19-inch rack, as shown below.Remove the feet of the unit before mounting.NOTELeave 1U of space above the unit for ventilation.•Allow at least 10 cm (4 in) at the rear of the unit for•ventilation.This product has been designed and manufacturedaccording to FDA regulations "title 21, CFR, chapter1, subchapter J, based on the Radiation Control forHealth and Safety Act of 1968", and is classified asa class 1 laser product. There is no hazardous invis-ible laser radiation during operation because invis-ible laser radiation emitted inside of this product iscompletely confined in the protective housings.The label required in this regulation is shown at 1.Optical pickupType : HOP-6201TCManufacturer : Hitachi Media Electronics Co,Ltd.Laser output : Less than 75 mW on the objective lens(record)Wavelength : 777 to 787 nmCAUTION• DO NOT REMOVE THE PROTECTIVE HOUSINGUSING A SCREWDRIVER.• USE OF CONTROLS OR ADJUSTMENTS ORPERFORMANCE OF PROCEDURES OTHER THANTHOSE SPECIFIED HEREIN MAY RESULT INHAZARDOUS RADIATION EXPOSURE.• IF THIS PRODUCT DEVELOPS TROUBLE,CONTACT YOUR NEAREST QUALIFIED SERVICEPERSONNEL, AND DO NOT USE THE PRODUCTIN ITS DAMAGED STATE.• CLASS 1M INVISIBLE LASER RADIATION WHENOPEN AND INTERLOCKS DEFEATED. DO NOTVIEW DIRECTLY WITH OPTICAL INSTRUMENTS.Safety Information1 For USA