2 − Controls and connectorsTASCAM SS-CDR1 13Remote control unit (RC-SS1)1 FLASH LOAD key This loads the registered tracks inpreparation for Flash Start. When the tracks have beenloaded, the display will indicate FLASH (see “Flash Startfunction” on page 36).2 DEVICE SELECT key This key has the same functionas the front panel SELECT key.3 DISPLAY key This has the same function as the frontpanel DISPLAY (INFO) key.4 TIME key If you press this key while in the home screen,the time display mode of the recorder will change (see“Switching the playback time display mode” on page 28,“Switching the recording time display mode” on page44).5 P.MODE key This switches the playback mode be-tween CONTINUE (normal consecutive playback),SINGLE (play one song), PROGRAM (program play-back), and RANDOM (random playback) (see “Play-back modes” on page 27).6 A. CUE key This turns the Auto Cue function on/off(see “Auto Cue function” on page 32).Rear paneld ANALOG INPUTS L/R (BALANCED) jacks These areanalog input jacks (XLR balanced).The nominal input level is +4 dBu.Pin wiring: pin 1 = ground, pin 2 = hot, pin 3 = cold.f ANALOG INPUTS L/R (UNBALANCED) jacks Theseare analog input jacks (RCA pin jacks).The nominal input level is -10 dBV.g ANALOG OUTPUTS L/R (UNBALANCED) jacksThese are analog output jacks (RCA pin jacks).The nominal output level is -10 dBV.h ANALOG OUTPUTS L/R (BALANCED) plugs Theseare analog output plugs (XLR balanced).The nominal output level is +4 dBu.Pin wiring: pin 1 = ground, pin 2 = hot, pin 3 = cold.j DIGITAL IN/OUT (COAXIAL) jacks These are digital in-put/output jacks compatible with IEC-60958 (S/PDIF).k CONTROL I/O (RS-232C) connector This is a D-sub9-pin RS-232C connector for control I/O. You canconnect it to an external computer or other device (see“Using the RS-232C connector” on page 79).l CONTROL I/O (PARALLEL) connector This is a D-sub 25-pin parallel connector for control I/O. You canconnect it to an external controller. For the pin wiring,refer to “Control connection” on page 10.; REMOTE IN connector Connect the RC-SS1 dedi-cated remote here.z AC IN connector Connect the included power cablehere.