6 − Recording46 TASCAM SS-CDR1Sync Record operationWhen you put the SS-CDR1 in record-ready condition withthe Sync Record function on, recording will automaticallystart or stop according to the level of the input source.When a signal higher than the sync level is input,•recording will begin automatically.However, recording will not begin even if input isdetected unless there has been at least one second inwhich the signal was below the sync level after enteringthe record-ready state.Start of recordingLevelTimeSYNC LEVELNOTEThe above explanation is for the case when theDELAY setting is “0” (the default setting). By changingthe DELAY setting, you can change the “record start”point.While recording, if the input signal stays below the synclevel for the duration specified by STOP TIME (default:5 seconds), the SS-CDR1 will automatically switch tothe record-ready condition.SYNC LEVELSTOP TIMEREC readyTimeLevelNOTEIf you set the STOP TIME to INF, the record-pausestate will not be entered even though the input signalcontinuingly falls below the sync level.To defeat Sync Record, press the remote’s SYNC REC key.When the sync level is too high:• If the sync level setting is too high, you may have prob-lems such as failing to capture the beginning of a songthat begins with a low volume.SYNC LEVELLevelThis part of the trackmay not be recordedTimeRecording startsIf the sync level is too low:• Sync recording will not begin if the source you’rerecording has a high noise level, so that the sync level isexceeded immediately when you enter the record-readystate.LevelSYNC LEVELTimeNoise is higherthan thresholdStart of track is not registered