April 20172-82 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer012-161BLaunch IssueStatus Indicator RAPs012-161B Set Eject Jam RAPBSD-ON:BSD 13.10 Office Finisher LX Tamping and Offset (2 of 2)BSD-ON: BSD 13.13 Office Finisher LX Eject Control (1 of 2)ProcedureNOTE: Ensure the correct RAP is performed, refer to the 012-161 Set Eject Jam Entry RAP.WARNINGEnsure that the electricity to the machine is switched off while performing tasks that donot need electricity. Refer to GP 10. Disconnect the power cord. Electricity can causedeath or injury. Moving parts can cause injury.Enter dC330 012-151. Actuate the compiler tray no paper sensor, PL 13.28 Item 9. The dis-play changes.Y NCheck the wiring between J8880 pin 2 and P/J8994 pin 2 on the finisher PWB for anopen or short circuit, or a loose or damaged connector. The wiring is good.Y NReconnect or repair as necessary.Measure the voltage between P/J8994 pins 1 and 3 on the finisher PWB. The voltage isapproximately +5VDC.Y NInstall a new finisher PWB, PL 13.45 Item 2.Measure the voltage between P/J8994 pin 2 on the finisher PWB and ground. Actuate thecompiler tray no paper sensor. The voltage changes.Y NInstall a new compiler tray no paper sensor, PL 13.28 Item 9.Install a new finisher PWB, PL 13.45 Item 2.Enter dC330 code 012-055. The eject motor runs.Y NCheck the wiring between P/J8878 on the eject motor and P/J8983 on the finisher PWBfor an open or short circuit, or a loose or damaged connector. The wiring is good.Y NReconnect or repair as necessary.Measure the resistance of the eject motor between P/J8878 pins 1, 3, 4 and 6. Theresistance is approximately 20 Ohms.Y NInstall a new eject motor, PL 13.27 Item 4.Install a new eject motor, PL 13.27 Item 4. If the fault persists, install a new finisher PWB,PL 13.45 Item 2.Check the components that follow:• The exit roller, entrance roller, paddle shaft and eject belt for wear, damage or contamina-tion, PL 13.29.• The compiler tray no paper sensor and eject motor circuits for an intermittent condition.If the fault persists, install a new finisher PWB, PL 13.45 Item 2.AA
