April 20178-63Xerox® VersaLink® B7025/B7030/B7035 Multifunction PrinterProduct Technical OverviewLaunch IssueIntegrated Office FinisherOverviewThe Integrated Office Finisher transports prints from the IOT to the compile tray where they arecompiled and tamped into sets. The sets then are stapled and or offset (as specified) and deliv-ered to the stack tray.As the paper is transported past multiple sensors, signals are sent to the finisher PWB controllogic that regulate various motors and solenoids used in the Integrated Office Finisher. Refer toFigure 1.Figure 1 Components overviewSupported Paper SizesThe Integrated Office Finisher is capable of handling a wide range of paper sizes, includingpost cards and envelopes. The sizes of paper for which the stack tray, stapling function, or off-set function is available are listed on the paper sizes for integrated finishers pdf.Maximum Paper Quantity for StaplingSmall-sized paper: (paper with a lead edge length of 297mm or less such as A4 (LEF/SEF) or8.5x11 (LEF/SEF)) - 50 sheets (24lb/90gsm or less) or equivalent. Paper quantity for staplingcan be changed in NVM from 10 to 70 sheets but stapling 51 or more sheets of paper is notguaranteed.Large-sized paper: (paper with a lead edge length of more than 297mm such as 8.5x14 (SEF)or A3 (SEF)) - 30 sheets (24lb/90 gsm or less) or equivalent. Paper quantity for stapling can bechanged in NVM. (10 to 50 sheets)Mixed sizes of paper: Sheets of paper of the same width can be stapled, however, if even onesheet of paper that is equivalent to a large size is included in a set, the value for large sizepaper is used as the limiting quantity. There is no stapling option available for mixed sizes ofpaper of different widths.
