April 20172-40 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer005-136, 005-147Launch IssueStatus Indicator RAPs005-136 DADF Side 2 Registration Sensor On Jam RAPBSD-ON: BSD 5.6 Document Scan, Invert and Exit Transportation005-136 After the DADF pre registration sensor turned on at invert operation, the DADF regis-tration sensor did not turn on within the specified time.ProcedureWARNINGEnsure that the electricity to the machine is switched off while performing tasks that donot need electricity. Refer to GP 10. Disconnect the power cord. Electricity can causedeath or injury. Moving parts can cause injury.Refer to the procedures that follow as necessary:• GP 6 How to Check a Motor.• GP 7 How to Check a Sensor.• GP 8 How to Check a Solenoid or Clutch.Perform the steps that follow:1. Check for a foreign substance in the document path.2. Check the surface of the exit roll, takeaway roll and registration roll for foreign substancesor wear. Clean or install new components as necessary, PL 5.50.3. Enter dC330, code 005-110. Check the DADF registration sensor, PL 5.70 Item 3.4. Enter dC330, code 005-206. Check the DADF pre registration sensor, PL 5.70 Item 3.5. Enter dC330, code 005-008. Check the DADF feed motor, PL 5.30 Item 3.6. Enter dC330, code 005-098. Check the DADF takeaway clutch, PL 5.35 Item 2.7. Check the exit nip roll, PL 5.65 Item 17. Enter dC330, code 005-072. Check the exit niprelease solenoid, PL 5.35 Item 8.8. Check the drive gears, PL 5.35 for wear or damage. Install new components as neces-sary.9. If the fault persists, install a new DADF PWB, PL 5.10 Item 11.005-147 DADF Pre Registration Sensor Off Jam DuringInverting RAPBSD-ON: BSD 5.4 Document Feeding (1 of 2)005-147 After the DADF feed motor started the reverse rotation at invert operation, the DADFpre registration sensor did not turn off within the specified time.ProcedureWARNINGEnsure that the electricity to the machine is switched off while performing tasks that donot need electricity. Refer to GP 10. Disconnect the power cord. Electricity can causedeath or injury. Moving parts can cause injury.Refer to the procedures that follow as necessary:• GP 6 How to Check a Motor.• GP 7 How to Check a Sensor.• GP 8 How to Check a Solenoid or Clutch.Perform the steps that follow:1. Check for a foreign substance in the document path.2. Check the surface of the exit roll, takeaway roll, registration roll and out roll for foreignsubstances or wear. Clean or install new components as necessary, PL 5.50.3. Enter dC330, code 005-206. Check the DADF pre registration sensor, PL 5.70 Item 3.4. Enter dC330, code 005-008. Check the DADF feed motor, PL 5.30 Item 3.5. Check the exit nip roll, PL 5.65 Item 17. Enter dC330, code 005-072. Check the exit niprelease solenoid, PL 5.35 Item 8.6. Check the drive gears, PL 5.35 for wear or damage. Install new components as neces-sary.7. If the fault persists, install a new DADF PWB, PL 5.10 Item 11.
