April 20172-100 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer013-212, 013-213Launch IssueStatus Indicator RAPs013-212, 013-213 Booklet Staple Move Position Sensor FailRAPBSD-ON: BSD 13.16 Office Finisher LX Booklet Staple Positioning013-212 Booklet staple move position sensor does not actuate within designated time period.013-213 Booklet staple move position sensor does not deactuate within designated timeperiod.Initial ActionsWARNINGEnsure that the electricity to the machine is switched off while performing tasks that donot need electricity. Refer to GP 10. Disconnect the power cord. Electricity can causedeath or injury. Moving parts can cause injury.• Ensure the staple head is free from obstructions.• Check dC122 Fault History for 013-306 or 013-307 faults. If either fault is listed, first per-form the relevant procedure:– 013-306 Booklet Safety Switches Open RAP.– 013-307 Booklet Cover Open RAP.ProcedureEnter dC330 code 013-144. Move the booklet stapler to actuate the booklet staple move posi-tion sensor, PL PL 13.55 Item 13. The display changes.Y NCheck the wiring between J8898 pin 2 and P/J8991 pin 5 and between J8984 pin 5 andJ8985 pin 5 for an open or short circuit, or a loose or damaged connector. The wiring isgood.Y NReconnect or repair as necessary.Measure the voltage between P/J8991 pins 4 and 6 on the booklet PWB. The voltage isapproximately +5VDC.Y NInstall a new booklet PWB, PL 13.70 Item 4.Measure the voltage between P/J8991 pin 5 on the booklet PWB and ground. Actuatethe booklet staple move position sensor. The voltage changes.Y NInstall a new booklet staple move position sensor, PL 13.55 Item 13.Measure the voltage between J8895 pin 5 on the finisher PWB and ground. Actuate thebooklet staple move position sensor. The voltage changes.Y NInstall a new booklet PWB, PL 13.70 Item 4. If the fault persists, install a new finisherPWB, PL 13.45 Item 2.Install a new finisher PWB, PL 13.45 Item 2.Enter dC330 code 013-028 and 013-029 alternately. The stapler move motor runs.Y NCheck the wiring between P/J8992 pins 1 to 6 on the booklet PWB and P/J8906 on thebooklet stapler move motor for an open or short circuit, or loose or damaged connectors.The wiring is good.Y NReconnect or repair as necessary.Monitor the voltage at J8984 pin 3. Enter dC330 code 013-028 and 013-029 alternately.An AC clock pulse is detected.Y NCheck the wiring between J8984 pin 3 and J8985 pin 4. If the wiring is good, installa new finisher PWB, PL 13.45 Item 2.Install a new booklet stapler move motor, PL 13.55 Item 9. If the fault persists, install anew booklet PWB, PL 13.70 Item 4.Check the wiring for an intermittent fault.AA
