April 20172-68 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer012-224, 012-263, 012-224A, 012-263ALaunch IssueStatus Indicator RAPs012-224, 012-263 Rear Tamper Home Sensor Fail EntryRAP012-224 The rear tamper home sensor failed to actuate within the specified time.012-263 The rear tamper home sensor failed to deactuate within the specified time.ProcedureGo to the relevant procedure:• Integrated office finisher installed, 012-224A, 012-263A Rear Tamper Home Sensor FailRAP.• Office finisher LX installed, 012-224B, 012-263B Rear Tamper Home Sensor Fail RAP.012-224A, 012-263A Rear Tamper Home Sensor Fail RAPBSD-ON: BSD 12.4 Integrated Office Finisher Tamping and OffsetInitial ActionsNOTE: Ensure the correct RAP is performed, refer to the 012-224, 012-263 Rear TamperHome Sensor Fail Entry RAP.WARNINGEnsure that the electricity to the machine is switched off while performing tasks that donot need electricity. Refer to GP 10. Disconnect the power cord. Electricity can causedeath or injury. Moving parts can cause injury.• Check the rear tamper home sensor, PL 12.25 Item 9 is correctly installed and has no for-eign object and that the actuator is not broken.• Switch off, then switch on the machine, GP 10.ProcedureCheck the rear tamper for any foreign object, deformation and binding that prevents it frommoving. The rear tamper is good.Y NRepair the deformation and remove the foreign object(s) and the binding. Install new com-ponents as necessary, PL 12.26.Check the drive mechanism to the rear tamper for a deformed or broken part and not-seatedgears. The drive mechanism is good.Y NRepair the rear tamper drive mechanism. Install new components as necessary, PL12.26.Enter dC330 code 012-221. Manually move the rear tamper to actuate the front tamper homesensor. The display of changes.Y NCheck the connections of P/J8700 and P/J8726. The connectors are good.Y NSecure the connections.Check for an open or short circuit between P/J8700 and P/J8726. The wiring is good.Y NRepair the open wire or short circuit.Measure the voltage between the finisher PWB P/J8700 pin 12 (+) and ground (-). Thevoltage is approximately +5VDC.Y NCheck the +5VDC circuit. Refer to the Wiring Diagrams.Measure the voltage between the finisher PWB P/J8700 pin 11 (+) and ground (-). Manu-ally move the rear tamper to actuate the front tamper home sensor. The voltagechanges.A
