April 20172-94 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer012-295, 012-296, 012-300Launch IssueStatus Indicator RAPsEnter dC330 code 012-045 and 012-042 alternately. The stapler move motor runs.Y NCheck the wiring between P/J8981 pins 13 to 16 on the finisher PWB and P/J8888 onthe stapler move motor for an open or short circuit, or loose or damaged connectors. Thewiring is good.Y NReconnect or repair as necessary.Install a new staple move motor assembly, PL 13.20 Item 9. If the fault persists, install anew finisher PWB, PL 13.45 Item 2.Check for an intermittent connection. If the check is good, install a new stapler assembly, PL13.20 Item 4. If the fault persists, install a new finisher PWB, PL 13.45 Item 2.012-300 Eject Cover Open RAPBSD-ON: BSD 13.3 Office Finisher LX Interlock Switching012-300 Eject cover switch open was detected.Initial ActionsWARNINGEnsure that the electricity to the machine is switched off while performing tasks that donot need electricity. Refer to GP 10. Disconnect the power cord. Electricity can causedeath or injury. Moving parts can cause injury.• Ensure that the eject cover, PL 13.25 Item 1 is closed.• Check the eject cover switch, PL 13.27 Item 19 for improper installation.• Check eject cover switch connectors for connection failure.• Check the switch actuator for damage.ProcedureEnter dC330 code 012-300. Actuate the eject cover switch. The display changesY NCheck the wiring between J8889 pin 1 and 2 for an open or short circuit, or loose or dam-aged connectors. The wiring is good.Y NInstall a new eject cover switch, PL 13.27 Item 19.Check the wiring between J8889 on the eject cover switch and J8982 on the finisher foran open or short circuit, or loose or damaged connectors. If the check is good, install anew finisher PWB, PL 13.45 Item 2. The wiring is good.Y NReconnect or repair as necessary.Install a new finisher PWB, PL 13.45 Item 2.Install a new finisher PWB, PL 13.45 Item 2.A
