April 20172-320 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer024-926, 963, 990, 024-928Launch IssueStatus Indicator RAPs024-926, 963, 990 Puncher Waste Bin Not Set RAPBSD-ON: BSD 13.6 Office Finisher LX Punch024-926 The puncher waste bin is not installed correctly or there is a failure in the punch boxset sensor or related circuitry.024-963 The amount of waste has become equal to or over the number that makes the punchdust box full.024-990 Punch dust full.Initial ActionsWARNINGEnsure that the electricity to the machine is switched off while performing tasks that donot need electricity. Refer to GP 10. Disconnect the power cord. Electricity can causedeath or injury. Moving parts can cause injury.• Empty the punch box, PL 13.06 Item 11.• Check for any debris or obstructions in the path of the punch waste bin or the punch boxset sensor.ProcedureEnter dC330, code 012-275, punch box set sensor. Remove, then reinstall the punch wastebin. The display changes.Y NCheck the punch box set sensor, refer to GP 7 How to Check a Sensor. Install new com-ponents as necessary:• Punch box set sensor, PL 13.09 Item 5.• (Integrated office finisher) finisher PWB, PL 12.14 Item 1.• (Office finisher LX) finisher PWB, PL 13.45 Item 2.Reload the software, GP 4. If the fault persists, install a new finisher PWB (integrated office fin-isher), PL 12.14 Item 1 or (office finisher LX), PL 13.45 Item 2.024-928 Scratch Sheet Compile Entry RAP024-928 Abnormal paper (scratch sheet), which is notified from the IOT via the sheet integritycommand, was output to the finisher.ProcedurePerform the relevant procedure:• Integrated office finisher installed, 024-928A Scratch Sheet Compile RAP.• Office finisher LX installed, 024-928B Scratch Sheet Compile RAP.
