April 20172-97Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer 012-903B, 012-905Status Indicator RAPsLaunch Issue012-903B Compiler Exit Sensor On RAPBSD-ON: BSD 13.7 Office Finisher LX TransportationInitial ActionsNOTE: Ensure the correct RAP is performed, refer to the 012-903 Compiler Exit Sensor OnEntry RAP.WARNINGEnsure that the electricity to the machine is switched off while performing tasks that donot need electricity. Refer to GP 10. Disconnect the power cord. Electricity can causedeath or injury. Moving parts can cause injury.• Check the paper path for jammed pieces paper.• Clean the compiler exit sensor, PL 13.35 Item 10.ProcedureEnter dC330 code 012-150. Actuate the compiler exit sensor. The display changes.Y NCheck the wiring between J8869 pin 2 and P/J8988 pin 5 for an open or short circuit, ora loose or damaged connector. The wiring is good.Y NReconnect or repair as necessary.Measure the voltage between P/J8988 pins 6 and 4 on the finisher PWB. The voltage isapproximately +5VDC.Y NInstall a new finisher PWB, PL 13.45 Item 2.Measure the voltage between P/J8988 pin 5 on the finisher PWB and ground. Actuatethe compiler exit sensor. The voltage changes.Y NInstall a new compiler exit sensor, PL 13.35 Item 10.Install a new finisher PWB, PL 13.45 Item 2.If the fault persists, install a new finisher PWB, PL 13.45 Item 2.012-905 Compiler Tray No Paper Sensor Static Jam RAPBSD-ON: BSD 13.10 Office Finisher LX Tamping and Offset (2 of 2)012-905 Paper remains on the compiler tray no paper sensor.Initial ActionsWARNINGEnsure that the electricity to the machine is switched off while performing tasks that donot need electricity. Refer to GP 10. Disconnect the power cord. Electricity can causedeath or injury. Moving parts can cause injury.• Check the paper path for jammed pieces paper.• Clean the compiler tray no paper sensor, PL 13.28 Item 9.ProcedureEnter dC330 code 012-151. Actuate the compiler tray no paper sensor. The displaychanges.Y NCheck the wiring between J8880 pin 2 and P/J8994 pin 2 on the finisher PWB for anopen or short circuit, or a loose or damaged connector. The wiring is good.Y NReconnect or repair as necessary.Measure the voltage between P/J8994 pins 3 and 1 on the finisher PWB. The voltage isapproximately +5VDC.Y NInstall a new finisher PWB, PL 13.45 Item 2.Measure the voltage between P/J8994 pin 2 on the finisher PWB and ground. Actuatethe compiler tray no paper sensor. The voltage changes.Y NInstall a new compiler tray no paper sensor, PL 13.28 Item 9.Install a new finisher PWB, PL 13.45 Item 2.If the fault persists, install a new finisher PWB, PL 13.45 Item 2.
