April 20172-87Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer 012-221B, 012-223B, 012-224B, 012-263BStatus Indicator RAPsLaunch IssueY NCheck the +24VDC circuit. Refer to the Wiring Diagrams. If the fault persists,install a new finisher PWB, PL 13.45 Item 2.Install a new finisher PWB, PL 13.45 Item 2.Check the wiring between J8984 pins 18 to 22 on the finisher PWB and the front tampermotor P/J8884 for an open or short circuit, or a loose or damaged connector. The wir-ing is good.Y NReconnect or repair as necessary.Install a new front tamper motor, PL 13.28 Item 8. If the fault persists, install a new fin-isher PWB, PL 13.45 Item 2.Install a new finisher PWB, PL 13.45 Item 2.012-224B, 012-263B Rear Tamper Home Sensor Fail RAPBSD-ON: BSD 13.3 Office Finisher LX Interlock SwitchingBSD-ON: BSD 13.9 Office Finisher LX Tamping and Offset (1 of 2)BSD-ON: BSD 13.10 Office Finisher LX Tamping and Offset (2 of 2)ProcedureNOTE: Ensure the correct RAP is performed, refer to the 012-224, 012-263 Rear TamperHome Sensor Fail Entry RAP.WARNINGEnsure that the electricity to the machine is switched off while performing tasks that donot need electricity. Refer to GP 10. Disconnect the power cord. Electricity can causedeath or injury. Moving parts can cause injury.Manually operate the tamper mechanism. The tamper mechanism moves smoothly.Y NInstall a new components as necessary, PL 13.28.Enter dC330 code 012-221. Manually operate the tamper mechanism to actuate the rear tam-per home sensor. The display changes.Y NCheck the wiring between J8882 pin 2 and J8984 pin 8 for an open or short circuit, or aloose or damaged connector. The wiring is good.Y NReconnect or repair as necessary.Measure the voltage between J8984 pins 9 and 7 on the finisher PWB. The voltage isapproximately +5VDC.Y NInstall a new finisher PWB, PL 13.45 Item 2.Measure the voltage between J8984 pin 8 on the finisher PWB and ground. Manuallyoperate the tamper mechanism to actuate the rear tamper home sensor. The voltagechanges.Y NInstall a new rear tamper home sensor, PL 13.28 Item 8.Install a new finisher PWB, PL 13.45 Item 2.Enter dC330 012-026 and 012-029. The rear tamper motor runs.Y NMeasure the voltage between J8984 pin 14 on the finisher PWB and ground. The volt-age is approximately +24VDC.Y NMeasure the voltage between J8984 pin 4 on the finisher PWB and ground. Thevoltage is approximately +24VDC.A BA B
