12-22 CHAPTER 12: IP R OUTING COMMANDSset ipsource_based_routing enabled[no | yes]This command enables or disables source based routing on the specified interface.set ip source routeChange parameters in the routing table for the specified IP source route. Thiscommand has the following parameters:gateway metric Show Commandshow all ip networks Displays details for all configured IP networks.show ip counters Displays system-wide IP network statistics.Input CountersParameter Descriptioninterface_name The name of the interface to which to apply this command.enabled no - Do not allow source based routing on this interface.yes - Allow source based routing on this interface.Parameter Descriptionip_name_or_net_addr The network name or IP address of the source route to be changedgateway The network name or IP address of the gateway to which IPdatagrams with the specified source address should be routed.metric This specifies how many hops it is to the specified gateway.SHOW IP NETWORK ip SETTINGS:Interface: eth:1Network Address: 151.104.196.166/CFrame Type: ETHERNET_IIStatus: ENABLEDReconfigure Needed: FALSEMask: 255.255.255.0Station: 151.104.196.166Broadcast Algorithm: IETFMax Reassembly Size: 8192WAN Type: N/ARemote IP Address: 0.0.0.0IP Routing Protocols: NONEIP Routing Metric: 1RIP Interface ExportMetric:0IP RIP RoutingPolicies:IP RIP AuthenticationKey:
