28-4 CHAPTER 28: TFTP C OMMANDSAlso see the disable tftp request , enable tftp request, and list traceroute commands.Delete Commands This section describes the following Delete-related TFTP commands: delete tftp client delete tftp request delete tftp clientThe delete tftp client command removes the specified IP host name or IP addressfrom the list of addresses authorized to use TFTP. Use the list tftp clientscommand to see the currently allowed addresses.delete tftp requestRemoves specified TFTP entries in the TFTP Client Request Table created with theadd tftp request command.Enable Commandsenable tftp requestThe enable tftp request command activates a request for service (get or put)from the TFTP server created with the add tftp request command. Use the listtftp request command to display TFTP request status.Also see the add tftp request , disable tftp request, and list traceroute commands.Disable Commandsdisable tftp requestThe disable tftp request command deactivates a request for service (get or put)from the TFTP server created with the add tftp request command.Also see the add tftp request , enable tftp request, and list traceroute commands.Set Commands The set tftp request command configures requests to the TFTP server createdwith the add tftp request command. Entries placed in the TFTP Client RequestTable are the names of files that are either requested from or sent to the TFTPserver.set tftp requestThe following parameters are associated with this command:action [get | put]max_timeout <1-300>mode [ascii | octet]rexmt_timeout <1-60>max_timeout Interval in seconds OfficeConnect Gateway waits for a response fromthe TFTP server before the TFTP request is cancelled. The range is1-300. The default is 25 seconds.Parameters Description
