|
25-2 CHAPTER 25: SNMP C OMMANDSAdd Commands This section describes the following Add-related SNMP commands: add snmp community add snmp community_pool add snmp trap_community add snmp trap_community_pool addresses add snmp communityThe add snmp community command adds to a table ofSNMP-authorized users.The following parameters can be configured for the add snmp communitycommand.address access [ro | rw | adm]community_pool validate_address [use_address | use_pool]If you don't want to restrict SNMP access to a particular IP address, specify theaddress as "0.0.0.0" (public). The community name and IP address of SNMPrequests from administrators on the network must match the list, which you canview using the list snmp communities command. The following table describesthe parameters associated with the add snmp community command.add snmpcommunity_poolThe add snmp community_pool command adds an entry to theSNMP Community address Pool table. This command is used in conjunction withthe add snmp community command to allow multiple management stationcontrol of the OfficeConnect Gateway through a pool of IP addresses. Thefollowing parameter can be configured for the add snmp community_pool command.Parameter Description Group name that authorizes SNMP requests.address IP address of the remote SNMP manager, in the form nnn.nnn.nnn.nnnaccess Determines what type of access to SNMP MIBs the specified user has.Options:Read Only (RO) - user-level objectsRead Write (RW) - user-level objectsAdministrator (ADM) - Administrator allows read access to all objectsand write access to all writable objects. RO is the default on public(0.0.0.0) networks and RW the default on private networks.community_pool Name of the SNMP community pool to use.validate_address When set to use_address the address of the SNMP community is used tovalidate the management station’s IP address. When set to use_pool,the management station’s IP address is validated against the list of IPaddress associated with the community_pool. The default isuse_address.
|
