PPPoE Commands 18-3disable pppoe oninterface This command disables the specified interface from sending or receiving framescarrying the new ether-type defined by the PPPoE protocol.Set Commandset pppoe The set pppoe command sets the following parameters for PPPoE sessionsmax_sessions max_sessions_per_host List Commandslist pppoe The list pppoe command shows information about PPPoE interfaces, servicenames, and sessions. It has the following parameters:bindingsservice_namessessionsThese parameters are described in the following table.list virtual connections Lists all of the PPP over Ethernet (PPPoE) connections coming into theOfficeConnect Gateway as well as tunneled connections such as PPTP. Thiscommand exists in addition to the list tunnel connections command which onlydisplays the virtual connections made by PPTP.Parameter Descriptionmax_sessions The maximum number of PPPoE connections that may be initiatedconcurrently to the OfficeConnect Gateway by all hosts combined.max_sessions_per_host The maximum number of PPPoE connections that may be initiatedconcurrently by a single host to the OfficeConnect Gateway. Thishelps to limit the Denial of Service attacks on the OfficeConnectGateway.Parameter Descriptionbindings This lists all the interfaces where PPPoE has been enabled and the status.service_names The service name is typically the name of the ISP or any QOSparameters.Presently the service names are just strings with no QOS significanceattached. The client may send a service name as a NULL string indicatingthat any service is acceptable in which case no service names need to beconfigured in the OfficeConnect Gateway. If the client request containsa non-null service name in the request, then the same name has to beconfigured in the OfficeConnect Gateway.sessions This command lists all of the existing PPPoE sessions and their peeraddresses in the concentrator.
