3Com OfficeConnect 3C100XF Cli User's Manual

Also see for OfficeConnect 3C100XF: Quick start guide

Contents

3Com OfficeConnect 3C100XF Cli User's Manual Manual pdf 197 page image

Enable Commands 25-5The parameters associated with this command are described in the followingtable.See add snmp trap_community_pool and list snmp trap_community_poolscommands for more information.Enable Commands This section describes the following Enable-related SNMP commands: enable link_traps_interface enable security_option snmp user_access enable snmp authentication trapsenable link_trapsinterfaceThe enable link_traps interface command informs SNMP to send linkup andlinkdown traps for the specified interface. We recommend you disable this featureon all modem interfaces to eliminate a barrage of perfunctory awarenessmessages forwarded from the NMC to the OfficeConnect Gateway alarm serverwhenever modem states change or the OfficeConnect Gateway reboots.The following parameter can be configured for this commandinterface_name Although the default is Disabled on modem interfaces, Hubs with Quad Modemsinstalled must have the OfficeConnect Gateway setting disabled manually to effectthe change. The command is enabled for Ethernet and WAN connections.Also see the disable link_traps interface and show interfacenterface_name> settings commands.enable security_optionsnmp user_accessThe enable security_option snmp user_access command allows SNMP accessto the User Table. This lets remote users use SNMP to access the CLI andreconfigure the OfficeConnect Gateway. Use the show security_optionscommand to see the current security values.enable snmpauthentication trapsThe enable snmp authentication traps command informs SNMP to send trapsfor both local and remote authentication. The default is enabled.Also see the disable snmp authentication traps, and show snmp commands.Parameter Description Pool name defining who can receive SNMP traps.IP address list IP addresses of all SNMP managers associated with the pool, in the formnnn.nnn.nnn.nnn.