Show Commands 4-5 Type - type of configured user. See the add user command for moreinformation.Show Commands This section describes the show user and showshow user The show user command displays the parameters defined for thespecified user.settingsall_settings settings - Displays settings for the specified user with the exception ofdisabled IP, Tap Status and Tunnel Type parameters. all_settings - Displays all settings for the specified user.The type of information displayed depends on the type of user you specify. Youcan issue the list users command to see which users are defined, and what type(s)user each is. An example of the information displayed for a user is shown in thefollowing table. Note that this user may not be typical. Defaults are indicated by(D). set maximum_local_users USERSLogin NetworkUser Name Service Service Status Typecurly TELNET (D) PPP (D) ACTIVE LOGINDIALOUTMANAGEdefault TELNET PPP INACTIVE NETWORKadministrator TELNET (D PPP (D ACTIVE LOGINMANAGEINFORMATION FOR USER: joeadminStatus: ACTIVEType: LOGINNETWORKTUNNELMANAGEExpiration: NONEDNIS Re Authentication: REAUTH_ANYSpecial Xon Xoff Flow Control DISABLEDNAT Option: INVALIDIntelligent NAT State: DISABLEDIntelligent NAT defaultworkstation:0.0.0.0Policy Filename:Telnet Options: NoneInput Filter: (D)Output Filter: (D)Session Timeout in seconds: 0 (D)Idle Timeout in seconds: 0 (D)Tap Status: DISABLEDTap Format: ASCII
