|
16-4 CHAPTER 16: CONFIGURING YOUR WAN P ROTOCOL S ETTINGS3 Enter the following command if you know the Local and Public Wan IP Address,and are not using DHCP:OCG-Adsl>> add ip network <1483> interface frame address <1.1.1.1/c> remote_address <1.1.1.3/c> wan_type routing_protocols enabled yes(Note: - the address ranges of both Public and Private IP address should be in thesame subnet.)4 Use the NAT/PAT configuration described in the next section, Address Translation,to create the appropriate NAT / PAT Policy.RFC 1483 - MER The following example shows the CLI commands that are used to configure RFC1483- MER from the CLI:1 Create an interface:OCG-Adsl>> add atmaal5 pvc <atmpvc> vpi <0> vci <35> interfaceatmaal:1(This creates an Interface with the name: atmaal:1/atmpvc2 Enter the following command if using DHCP:OCG-Adsl>> add ip network <1483MER> interface <atmaal:1/atmpvc>frame atm1483MER wan_type auto enabled yes3 Enter the following command if you know the Local and Public Wan IP Address,and are not using DHCP:OCG-Adsl>> add ip network <1483MER> interface frame address <1.1.1.1/c> remote_address <1.1.1.3/c>wan_type routing_protocols enabled yes(Note: - the address ranges of both Public and Private IP address should be in thesame subnet.)4 Use the NAT/PAT configuration described in the next section, Address Translation,to create the appropriate NAT / PAT Policy.Address Translation The following procedures describe how to configure the address translationsettings of the OfficeConnect Gateway from the CLI.Configuring PortAddress TranslationBefore PAT options can be enabled and configured from the CLI, a User/Profilemust be created.PAT allows multiple private IP addresses to use one public IP address bydynamically and statically mapping each private IP source address and private IPsource port to one public IP source address and one public IP source port.
|
