7 VOICE AND VODSL C OMMANDSOverview If your OfficeConnect Gateway is equipped to handle data and voice, you can useit to receive both voice traffic and data traffic over your DSL line.This chapter identifies the Voice and Voice over DSL (VoDSL) commands that canbe accessed from the CLI of the OfficeConnect Gateway. The information in thischapter is organized into two sections: Voice Interface Commands VoDSL CommandsVoice InterfaceCommandsThis section identifies and describes the Voice Interface commands accessible fromthe OfficeConnect Gateway CLI. The following table identifies these commands:Set Commandset voice interfaceUse this command to set the following parameters for a voice interface.txgain >rxgain state [closed | idle | voice | fax | dtmf | modem]ring_frequency [alert_tone 1 | alert_tone 2 | alert_tone 3 | alert_tone 4 |alert_tone 5 | alert_tone 6 | alert_tone 7 | alert_tone 8 | alert_tone 9 |alert_tone 10 | alert_tone_silent]ring_cadence [minus_r_ring | pattern_a_ring | pattern_b_ring |pattern_c_ring | pattern_d_ring | pattern_e_ring | pattern_f_ring |minus_t_ring | plus_r_ring | plus_t_ring | pattern_g_ring]echo_canceller [enable | disable]CommandTypeCommand NameList list voice interfacesSet set voice interface Show show voice interface show voice interfaceshow all voice interfaces
