28-2 CHAPTER 28: TFTP C OMMANDSFor example, at the OCG-Adsl>> prompt, type:tftp ENTERstatus ENTERThe command lists:List Commands This section describes the following List-related TFTP commands: list tftp clients list tftp requestslist tftp clients The list tftp clients command displays IP addresses of all users allowed to use theTrivial File Transfer Protocol (TFTP) to connect to the system. Use the add networkservice command to add TFTP support to the system, the add tftp clientcommand to authorize users to connect, and the add tftp request command toinitiate TFTP service.For example:list tftp requests The list tftp requests command displays statistics of all current requests forservice in the TFTP Client Request Table. It lists the following information: Filename - Name of file to be requested from or sent to the TFTP server. Server - Name or IP address of the TFTP server Action - Type of request send to the TFTP server. Put or Getget [remotefile][localfile]Receive a filehelp Print help informationmode [ascii | binary] Set file transfer mode: ASCII or Binaryput [localfile][remotefile]Send a filequit Exit TFTPrexmt Set the retransmission timeout interval. The range is 1-60. Thedefault is 5 seconds.status Show current TFTP request statustimeout Set maximum timeout interval. The range is 1-300. The default is 25seconds.trace Toggle packet tracingverbose Toggle verbose mode echoes command? Display help informationConnected to status.Mode: netascii Verbose: off Tracing: offRexmt-interval: 5 seconds, Max-timeout: 25secondsValue EffectTFTP CLIENT addresses0.0.0.0157.122.138.134234.122.156.134
